| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Post Processor Files Discuss post processor files here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-02-2010, 01:48 PM
| |||
| |||
Hellllooooo I need to remove line numbers from a UG post and can't quite figure it out. I do see lots of chatter about them in the .tcl file but no magic off switch in the post builder. More specifically, I need to make my block skips go before line numbers rather than after for a Milltronics mill. But, just removing line numbers will help me get back to my other never ending list of things to do.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Unigraphics | Rob_M. | General CAM Discussion | 29 | 02-03-2009 11:33 AM |
| Need NX 4 (Unigraphics) post for Mori msc-802 | cadcamman | Post Processor Files | 2 | 01-08-2008 10:31 AM |
| Need help! Post for acramatic 2100 using with unigraphics! | mrtckrc | Post Processor Files | 4 | 08-16-2006 08:21 AM |
| Unigraphics 5-axies mill post | timoty | Post Processor Files | 0 | 06-13-2005 12:46 PM |
| Unigraphics | NWPJOEL | General CAM Discussion | 1 | 04-28-2005 12:06 PM |
| | |
Linear Mode
