Mastercam not supporting V9.

[TheBigJW]

Just purchased a new Mori DuraVertical with fourth axis. Have x2 but still using V9 for a lot of things. All these years the typical answer for a post was "go ask your dealer".
Well I did that and this was the response.

"In regards to your request for the Mori Seki Post processor, please see the attached quote. Please note we can no longer provide any posts for Mastercam Version9 as it is no longer supported."

Anybody want to sell me a copy of thiers or can anyone suggest another company who can help us out with this.

John

[CNCRim]

Correct me if I'm wrong, but I thought there is C hook that will convert V9 post to X post.

[TheBigJW]

Correct me if I'm wrong, but I thought there is C hook that will convert V9 post to X post.

I don't have either post. Mori told me CncSoftware has a post for my machine that they have proved. I will have no problem getting a copy when my machine comes in. No it's here and they are saying because they are no longer supporting V9 they will not give or sell me a copy. I have been a customer since V8. We purchased V8,V9,X,X2. Man I hate that company. I can't wait to be free of them.

John