AHHA post for mastercam version 8

[kiinstructor]

Can anyone help me please. I have Mastercam version 8 and I have an AHHA 500 controller with ahha 3.1 software that runs in DOS. Does anyone has a post for AHHA that will work with mastercam V8. If so could you please share it with me. My email is mitou@charter.net .


Thanks so much
Mark
PH 715 356-4655

[CNCRim]

Generic post should work fine, go to website emastercam.com, she has it under post.

[kiinstructor]

Doesnt seem to work. Got a few errors to start with tool not recognized and something about center point to recognized. Any other ideas would be appreciated. Thanks Mark