- Edit Postprocessor
-
Registered
Edit Postprocessor
Hello . I have a problem. I have written about it before but nobody had the right answers to it, so I try again. I use Mach3 and AlphaCam 13. There is not a post processor for Mach3 , so I use " Fanuc 6MB (R arcs - mm ) " but that is to be corrected : prior comments will be put a " ' " but Mach3 requires comments in between "()" How do I change it ? Sincerely . Ib
Similar Threads:
Last edited by ibccnc; 05-31-2015 at 10:47 AM.
-
-
Member
Re: Edit Postprocessor
I think that you mean comment which are generate automatically for Alphacam. Something like
'(OP 1 SPIRALNI HRUBOVANI NASTROJ 4 FLAT - 50MM)
'(EFEKTIVNI PRUMER 50, PRIDAVEK 10)...
Try switch $540 from 0 to 1. Then this comment wil be disable.
-
Registered
Re: Edit Postprocessor
Thank you for your response. Yes it is the automatic generated AlphaCam files it comes . I will use your solution if no other option , but maybe I'll make a program that converts the file to the right including comments . Yours sincerely . Ib
- Edit Postprocessor
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules