I have a basic generic fanuc 2x lathe post, MCX 5.
I have the control def. configured to output canned cycles for drilling. My problem is, I get only "CUSTOMIZABLE DRILL CYCLE" output where the G81, G83 should be.
I found the part in th post that does this. I need help getting this straightened out please.

ldrill$ #Canned drill cycle, lathe
#Use this postblock to customize lathe drilling cycles 0 - 7
pdrlcommonb
"CUSTOMIZABLE DRILL CYCLE ", pfxout, pfzout, e$
pcom_movea

lpeck$ #Canned peck drill cycle, lathe
ldrill$

Similar Threads: