- Need Help!- Feeler FTC30 with Seimens 810D controller.
-
Registered
Feeler FTC30 with Seimens 810D controller.
I have feeler lathe FTC30 with Seimens 810D controller, Problem is that when we take offset on any diameter
and start program to cut, tool was came and plus extra 10mm in X Axis,but our position counter is currect but phisically tool is not correct position.
Can any one help me. I can highly appriciate on this.
Similar Threads:
-
- Need Help!- Feeler FTC30 with Seimens 810D controller.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules