Hello fellow CAM programmers!!


I am building a postproc for EdgeCAM to work with a Heidenhain 620 Controller (at a renewed Bridgeport VMC760/20).
I took as a base a TNC426 Heidenhain template I found at the EdgeCAM files, but I have some problems.
First of all, I cannot get a correct block format at the start of the code.
Secondly, I get a negative clearance at the sequences.
Lastly, as my sequences seem like corrupted inside the test run, it's like the "Q lines" are comments.


Has anyone worked with this kind of setup?

Similar Threads: