LinkBack URL
About LinkBacks
LOL, Heavy Metal is Inspirational for Aggressive Machining. I makes you want to increase the Feeds and Speeds 200% or More if the variables permit.
BTTW Machining.
| | |
Yes - individual radios are allowed
No - no radios allowed
Yes - 1 radio plays over a loud speaker/intercom
No - but what they don't know, won't hurt them
one earbud only. i think it helps with productivity. you don't feel like talking if you're listening to music
LOL, Heavy Metal is Inspirational for Aggressive Machining. I makes you want to increase the Feeds and Speeds 200% or More if the variables permit.
BTTW Machining.
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
If you're running screw machines you need to listen to the new wave of music...screamo.
4 machines running 3/8 hex bar stock at 2000rpm, and it don't matter. To my dad, 4 machines running 3/8 hex bar stock at 2000rpm WAS music.
We're allowed to have personal radios in our shop, but to be honest, its annoying as all get out. The problem we have is people hooking their phones or mp3 players up, then cranking their music, and spending half of their production time screwing with the playlists. If i had a vote, it would be for one standardized station or a single wireless stream point, but then again, i'm just a simple machinist
Posting Permissions
| | |
