What RS232 baud rate do you use - excluding HAAS?

[Frankenfab]

primarilly 9600.

On some of machines, I believe it is a changeable setting.

The Enshu, Moir Seiki lathe, and the Sharp we use 96000.

On the big Mori Seiki mill we are using 2400, because we couldn't get any thing else to work, and had to change channels to get that. I was just glad to get communication after typing things in by hand for 3 or 4 months.

On the HAAS SL20 & SL30, and the Okuma mill we just use the floppy.

[eng_semsem1980]

good day
I reinstall my soft ware mastercam and cimco software and after that my machine SCM with NUM750 controller not accept my data where when send program the machine not responce I change boudrate and try every thing
can you help me
best regards

[gar]

070902-0846 EST USA

eng_semsem1980:

I assume by your question that before you reloaded your software that you had successful RS232 communication, and that nothing else changed.

At your CNC machine determine the following settings:

Number of Data bits
Baud rate
Parity
Number of Stop bits
Handshake method (Software (XON/XOFF or DC codes or Xmodem), or Hardware (RTS/CTS) )

Use these same settings at the computer.

Report back what happens and what these values are.

.

[DryRun]

I Use 4800 7 Data Bits Even Party 1 Stop Bit Run It With Windows Hyper Terminal For All My Machines , Ido Have Ez-dnc And Perditor But Hyper Works Just Fine

[gar]

070908-1432 EST USA

DryRun:

Why do you operate at such a low baud rate?

.

[DryRun]

Lots of welders in the shop

[underthetire]

Most of our machines that are still on rs 232 are at 9600. Some of the very old machines from the 80s may still be at 4800, all the new moris, mazaks etc are on network or USB. The okumas use the floppy still. Mori server is included now with all the new machines, that works very well.

[txcncman]

Light speed.