Gcode commands for Plasmacam - CNCzone.com-The Largest Machinist Community on the net!

jeffery71 · #1 04-09-2008, 01:26 PM

Hi, I'm wondering what gcode commands plasmacam uses to fire the torch (i.e. M3) Also I'm assuming there is a way to call the "sence material height" from gcode?

Thanks

Jeff T.

Dan-RS244 · #2 10-26-2010, 12:34 PM

It doesn't use M-codes. G0, G1, G2 and G3
It seems to key off the G1 (ON) and G0 (OFF)

geo4932 · #3 11-01-2010, 09:50 AM

Could you clarify what are you trying to do with the gcode and the Plasmacam?

george

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Simple GCode Reference / Commands?	WarrenW	G-Code Programing	14	11-30-2010 04:03 AM
G2 and G3 Commands	Bohemund	G-Code Programing	19	05-28-2007 10:12 AM
Difference between BL and SV commands?	Shizzlemah	Fadal	3	03-23-2007 09:33 AM
I have a problem with my gcode or my conversion to gcode , everything is tiny?	NickLatech	G-Code Programing	0	03-10-2005 01:46 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)