Need Help! port - CNCzone.com-The Largest Machinist Community on the net!

jcochran · #1 03-20-2008, 05:31 PM

we had to get another computer for the plasmacam [dell] we put a parallel port in it, axxon, how do you set it up

ziptie007 · #2 03-27-2008, 07:29 AM

did you figure it out yet? If not I can sum up whats in my manual for you.

ziptie007 · #3 03-28-2008, 11:26 PM

well the scanner was acting funny soI'll just jot down the important stuff

" You must use a parrallel port configured for ps/2 mode. To do this you will probably have to enter the bios mode. The menu will probably be called "chipset features setup" under which the "parrallel port mode" can be found.Try to choose ps/2 or "bi-dirrectional"

That kind of sums it up. Since I have not actually done it I can't give any tips.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
USB port	fourperf	Haas Mills	4	02-02-2008 07:00 PM
PNP LPT Port	studysession	Mach Software (ArtSoft software)	15	12-29-2007 01:11 PM
serial port	lamicron	Computers and Networking	9	12-18-2007 11:42 AM
Help with LPT port!	honda	Industrial Hobbies (Support forum)	4	02-11-2007 02:47 PM
expanding lpt port	scott m	General Electronics Discussion	5	11-30-2004 08:33 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)