Newbie set-up - CNCzone.com-The Largest Machinist Community on the net!

jcochran · #1 03-13-2008, 05:31 PM

we have got a plasmacam 4x4 using a miller spectrum 375 torch. could someone give me the basic set-up on this combo? this is all new to us

reactive · #2 03-15-2008, 02:06 PM

sorry.ı don't hear this program

PlasmaCAM · #3 04-10-2008, 11:02 AM

Start with these settings.
Set the cut height to .07 and the arc voltage shift to .800

Also for faster response please contact PlasmaCAM support directly by phone at 719-676-2701 or use the Plasmacam_Techtalk or Plasmapig on Yahoo Groups.

Regards,
George

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)