Cutting speed setting in plasmacam - CNCzone.com-The Largest Machinist Community on the net!

01-29-2012, 05:00 AM

zak88

Join Date: Nov 2011

Location: Australia

Posts: 1

Cutting speed setting in plasmacam

permalink

Hi, I have a Samson 510 plasmacam.
Does any body know if it's possible to set different cutting speed in the program?
That is, if you are cuttig a simple square profile with 20 holes inside, can you set the cutting speed to cut the holes at slow speed and the outside square profile at a faster speed.
Thanks.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CNC Plasma Cutting System 4x4 PlasmaCAM Table Software	CNCadmin	EBAY ADS	0	03-24-2011 02:10 PM
Need Help!- Setting inch per minute cutting speed	Edwardo	DynaTorch	17	06-03-2009 09:21 AM
plasmacam stops cutting when air compressor goes on??	ziptie007	CNC Plasma and Waterjet Machines	8	04-30-2008 11:36 AM
I might have a good idea for setting up a hand torch on a plasmacam setup	ziptie007	CNC Plasma and Waterjet Machines	0	04-18-2008 09:09 AM
Trouble cutting 1/4" with plasma / plasmacam	sflraver	CNC Plasma and Waterjet Machines	5	10-02-2007 02:40 PM

All times are GMT -5. The time now is 01:08 AM.