Nearly every time the Z axis motor does its thing, aka, moves, I come up with a 194 error code. No other movement trips this code, only the z axis motor. I was wondering if anyone else had this issue. I'm heading out after work to pick up a new parallel cable hopefully with a little better shielding. (no worries, I'm going for the 6 footer ;-) )
I ended up moving the computer to a more remote location as well as moving the plasma cutter away from the table and computer as much as possible and this seems to have solved the issue. Another thing I did was made sure to plug the table itself into a NON GFI plug. Apparently they were serious about that.