Need Help! how to extend 4x4 plasmacam - CNCzone.com-The Largest Machinist Community on the net!

hardsteel · #1 09-10-2010, 05:11 AM

hi guys,I am going to buy a 4x4 plasmacam machine , and I am asking if there is a way to make it 4x8 and how . I prefer the lagre size like Samson , but Unfortunately it is over my budget ,so any advise or info will be very appreciated .

geo4932 · #2 09-14-2010, 12:27 PM

Originally Posted by hardsteel

hi guys,I am going to buy a 4x4 plasmacam machine , and I am asking if there is a way to make it 4x8 and how . I prefer the lagre size like Samson , but Unfortunately it is over my budget ,so any advise or info will be very appreciated .

You might want to join the Plasmapig Yahoo Group for info like that.

hardsteel · #3 09-14-2010, 01:26 PM

thank very much for your info geo4932 , I will try this .

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Want to extend Lathe Bed and have some questions	nsiters	Mini Lathe	1	08-03-2008 01:58 AM
New Machine Build- Extend width of TM1/TM2 by 1ft	schoobie	Torchmate	3	07-17-2008 03:07 PM
tailstock won't extend	burnin daylight	General CNC (Mill and Lathe) Control Software (NC)	0	03-19-2007 08:54 PM
tailstock won't extend	burnin daylight	Daewoo/Doosan	0	03-19-2007 03:35 PM
Trim and extend?	tinman13	BobCad-Cam	8	03-30-2006 10:11 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)