I decided to tig the whole table because it makes for a cleaner looking build.
I tried to use as much "scrap" steel I had laying around from an old trailer build that never got done.
I decided to have side drafts as well as the water because I want zero crap floating around in the air. Time will tell if this design works or not.
This table can be disassembled into small pieces. I did this for 2 reasons !! One, is that this will be going on the second floor of my shop, and this will make it a whole lot easier to get it up there. The second reason is that I want to be able to powder coat everything, and my oven is only 5 1/2' X 3 1/2'.