Tracker CNC software

[Jdracing55]

I have a tracker nitro plasma table and I was wondering if I could use another type of programming software rather than command n cut. The reason I am wanting to get away from Command n cut is because it does not have kurf width comp or lead outs. Does anyone know of any other software that I can use?

[plain ol Bill]

I use Sheetcam TNG and love it!

[Jdracing55]

Thanks for the reply. Do you have a tracker? if so what did you have to do to convert to sheetcam?

[plain ol Bill]

I don't have a tracker. I made my machine and use electronics fro CandCNC. So my control software is Mach3 and I use Sheetcam to generate my G code. Both are great programs and I highly reccomend them.

[Kerfit]

You could also use MTC Software. The NestMaster 2010 should work just fine in this application.

[cheech669]

We have a Tracker POS and put all new control, drivers... and proven software to run it. Also had to redesign the machine to give better then 1/8" tolerances.