Harbor Freight Plasma Cutter Retrofit for CNC Router

[jurban]

Hello,
I photographed the process of tapping into the trigger circuit for a Harbor Freight plasma cutter so that I could control it through my CNC router. The goal was to make the trigger non-permanent so that I could remove it from the CNC router and use it by hand. I then connected it to a relay board to isolate it from the controller. It works very well.

http://picasaweb.google.com/joseph.a...RouterControl#

Here is a video of the first test: YouTube- Torchmate + Harbor Freight Plasma Cutter Test
Comments for improvements are appreciated.

--Joe

[engineeron]

thanks to all my friends on cnc

[Made of Metal]

I have a quick question about using a Harbor Freight plasma with a Torchmate 2x4 system. Does the air cooling on the torch interfere with the cutting sequence. If so, does anyone know how to disable the air cooling feature on a Harbor Freight plasma unit.
Any help or past experiences would be appreciated.

[winegar]

No need... I use my Harbor Freight plasma cutter on my cnc table and it works fine!.... http://www.cnczone.com/forums/plasma...4x4_table.html