- Automatic tool messuring
-
Registered
Automatic tool messuring
Hello at all.
I changed software to TNG too.
Since the changing my z axis moves up to top limitswitch with max speed.
Thats nerv bad cause two of my switches are broken cause of this :-(
I tryed many parameters in settings but nothing works. If i set z axis to reverse, the z moves down an than direction messuring sensor.
issue one: I want that first axis x and y move to sensors koordinates and then the z.
issue two: messuring work surface is working wit not reverse z axis. If i set z reverse, messuring work surface dont work...
How to set parameters for correct working both kinds of messuring?
I use the same inputpin for both messuring sequenzes.
Regards
Alex from germany
Similar Threads:
-
-
Registered
Re: Automatic tool messuring
Solved.
I resettet settings and set parameters for Motors and directions again.
Now its working.
But somebody found the funktion for messuring the workposition x + y axis?
There is only the surfacemessuring...
- Automatic tool messuring
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules