EleksIVaxis

[net2001]

Hi, I need help about how to use the EleksIVAXIS with a laser diode 15w and configure usbcnc software settings.The board works fine, but I don't know how to configure the software. It works only with usbcnc and Planet-cnc's driver. Any feedbacks are appreciated.

Thanks in advance.

B.R
Francesco

P.s sorry for my english

[PlanetCNC]

Looks like you have one of Chinese counterfeit boards (these EleksMaker boards are new on the market ):
Planet CNC ? View topic - BEWARE - Chinese counterfeits

We do not support these boards. We cannot be responsible for any hardware or license malfunction.

​License that was included(usually on a CD) is pirated and we do not allow it.

You can license this product with our original controller license: https://planet-cnc.com/product/cnc-u...oller-license/

Best regards,
Team PlanetCNC

[net2001]

Thanks for reply.
I bought the board from banggood and looking in your attached post, I don't find my board.
So it means that should be original, made by EleksMaker.
https://www.banggood.com/USB-CNC-4-A...r_warehouse=CN

eleksivaxis | EleksMaker Official Wiki

But if you can guarante me that the "problem" is only the controller license, I'll open a dispute with the seller.

Thanks in advance,
B.r.
Francesco

[PlanetCNC]

This is another counterfeit board with pirated license.

[net2001]

Ok , I understand.
So, can you confirm me that it will works with your controller license? ( https://planet-cnc.com/product/cnc-u...oller-license/ )

Below the picture with option disabled


Thanks in advance
B.R,
Francesco

[PlanetCNC]

Unfortunately no...

These boards are based on our first Mk1 controller, so PlanetCNC software will recognise it as MK1 controller.
One of many disadvantages of Mk1 controllers is that it does not support PWM output signal.

[kirk-ericsson]

Hi net2001, I have recently purchased the same controller board. Did you ever have this software issue resolved??