- Question about Spindle Control and Planet-CNC output board setup YL620
-
Registered
Question about Spindle Control and Planet-CNC output board setup YL620
I am following Planet-CNC's Blog about how to setup my machine with their output board (https://planet-cnc.com/controlling-s...-output-board/) but of course my VFD is a little different and I don't fully understand electronics. The 5 connections I need to make from the output board are FOR, REV, DCM, VI, and ACM. I can find FWD and ReV, but I am unsure of the DCM, VI, and ACM. I will attached the pictures from my output boards book. I have a YL620 Thanks for your help
Similar Threads:
-
-
Member
Re: Question about Spindle Control and Planet-CNC output board setup YL620
Probably in you case:
DCM -> XGND
VI -> VI1
ACM -> GND
- Question about Spindle Control and Planet-CNC output board setup YL620
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules