I'm sure one of offsets is set to 250.
Are you using TNG?
Check working offset!
Check coordinate offset!
Check tool offset!
Hello.
I am having some issues with my z axis.
The offset is set to 0 and there is nothing else that I can think of that would interfere with this.
In the program Z, X and Y is showing 0.
When I write Z 10 it moves the z axis to 260, when I write Z 0 it moves to 250. If i write Z -250 it moves to 0.
What would cause this?
Similar Threads:
- Need Help!- 465-4 zaxis 2 alarm
- Need Help!- Hitachi Zaxis
- Zaxis repeatability
- counterbalancing the Zaxis.
- choosing Zaxis motor
Last edited by MrEmo; 06-27-2017 at 12:07 PM.
I'm sure one of offsets is set to 250.
Are you using TNG?
Check working offset!
Check coordinate offset!
Check tool offset!
I'm using regular program atm.
Checked, double checked and tripple checked all of them.
It drove me nuts. Tried going deep in the setting files aswell but I couldn't figure it out. So after 3 hours I just scrapped my setting files and started all over again. Took me 10 min to setup and everything seems to be working fine now.
I will test some more later this week and tell you how it's going.