Torque - CNCzone.com-The Largest Machinist Community on the net!

elogicca · #1 01-23-2007, 06:10 PM

Is it normal that i have more torque in 1/16 than 1/2 step mode? my steppers stall in 1/2 step at 40ipm but not in 1/16'th mode would figure it would be the opposite? freshly burn't chips too

Cooper · #2 01-24-2007, 04:29 AM

Hi,

It is very normal to get more "efficient" torque rate with smaller steps. Use the smallest step rate as possible. Btw, Could you share 1/16 picstep firmware please? Or e-mail to me?

Cooper

vasko · #3 07-02-2007, 01:03 AM

Where it is possible to take firmware for driver Mardus Kreutz

kreutz · #4 01-04-2008, 10:18 PM

Originally Posted by vasko

Where it is possible to take firmware for driver Mardus Kreutz

PM me.

Regards,

Kreutz.

tfmacz · #5 01-06-2008, 05:39 PM

Originally Posted by Cooper

Hi,

It is very normal to get more "efficient" torque rate with smaller steps. Use the smallest step rate as possible. Btw, Could you share 1/16 picstep firmware please? Or e-mail to me?

Cooper

http://www.fromorbit.com/projects/picstep/

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Torque	lgalla	Phase Converters and VFD	3	12-31-2006 04:33 PM
Where's me torque gone ?	George	Mach Mill	2	01-06-2006 06:34 PM
Am not getting the torque	adroitguy	Stepper Motors and Drives	13	07-13-2005 04:30 PM
Can I Get More Torque?	cbcnc	DIY-CNC Router Table Machines	38	04-14-2004 04:47 PM
Torque ?	motomitch1	General Electronics Discussion	2	01-26-2004 02:29 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)