| | |
I apologize if this has already been covered but I am getting ready to build a PICStep v4 controller and just wanted to make sure I am not crazy (I'm new to this). For the transfer method of board creation does the front copper image shown in the PDF version (on Alan's site) need to be mirrored while the back is already correct for transfer?
John W
http://home.comcast.net/~pwprojects
Didn't you read the thread on looking at it while standing on your head?
Just kidding, think about the fact that toner transfer puts the toner on the printed side which is the side that adhears to the blank copper.
Phil, Still too many interests, too many projects, and not enough time!!!!!!!!
Vist my websites - http://pminmo.com & http://millpcbs.com
Posting Permissions
| | |
LinkBack URL
About LinkBacks
