| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Phase Converters and VFD Running 3 phase machines on single phase power and variable frequency drive discussion |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-15-2009, 09:18 AM
| |||
| |||
hi i have a c11g rev 5.4 board , is it possible to control the direction of the spindle from mach and not only the on off function and speed. i have a commercial vfd with frw,rew and com terminals.  |
|
#2
11-25-2009, 06:54 PM
| ||||
| ||||
| Take a look at the wiring diagram here : http://www.machmotion.com/pdf/Mach3%20Setup%20Guide.pdf |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Setting up Mach3 + CNC4PC BOB + VSD-A-r2 | ftec | Granite Devices | 6 | 10-13-2009 06:04 PM |
| Problem- cnc4pc pendent | davidponte | Mach Mill | 1 | 12-26-2008 12:28 AM |
| CNC4PC C10 breakout board. | spaceballs_3000 | Benchtop Machines | 3 | 05-02-2008 03:10 PM |
| CNC4PC Boards | tz1238 | General Electronics Discussion | 2 | 11-02-2007 11:55 PM |
| Xylotex and cnc4pc | Eclipse | Xylotex | 7 | 12-21-2005 10:14 PM |
| | |
Linear Mode
