| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Phase Converters and VFD Running 3 phase machines on single phase power and variable frequency drive discussion |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-12-2009, 02:28 AM
| |||
| |||
Hi all, I have the following setup. A Fimec 5 kw Spindle controlled be a Delta VFD This VFD gets its signal (0-10vDC) from a Soundlogic Serial Spindle Control Card which in turn is controlled by Mach 3. My problem is that the spindle slows down after about 5 mins of running. The output voltage of the soundlogic card remains constant through all of this. Eventually the VFD Goes into a overload mode (because of the low speed )and the spindle motor stops. Any Ideas? Are there any free online guides / tutorials on how to set up a VFD?  |
|
#2
08-12-2009, 02:34 AM
| ||||
| ||||
| http://www.delta.com.tw/product/em/d..._manual_en.pdf http://www.delta-america.com/FileUpl...13_BQ06-EN.pdf
__________________ Patience and perseverance have a magical effect before which difficulties disappear and obstacles vanish. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ikegai FX20 Spindle speed issues | BKBridges | Fanuc | 9 | 08-13-2009 09:49 AM |
| Problem- Spindle speed issues... | rshields21 | Haas Mills | 3 | 04-16-2009 09:16 PM |
| Motor speed issues | rich_cree | Gecko Drives | 8 | 02-20-2009 07:57 PM |
| X3 spindle speed issues | Legion99999 | Syil Products | 5 | 12-08-2008 04:42 AM |
| speed issues | sixpence | DIY-CNC Router Table Machines | 10 | 09-18-2004 08:28 PM |
| | |
Spindle Speed Issues: !Please Help! 
Linear Mode
