vfd for rf 45 clone - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Electronics > Phase Converters and VFD
vfd for rf 45 clone

Phase Converters and VFD Running 3 phase machines on single phase power and variable frequency drive discussion

This forum is sponsored by:

08-01-2009, 10:09 AM

doc0302

Join Date: Jun 2005

Location: israel

Age: 32

Posts: 32

vfd for rf 45 clone

permalink

hi
i have a rf 45 clone with the folowing motor specs :

induction motor
380 V
3.2 A
1.5 hp
50 hz
4 poles

i curently have a rhymebus rm5g inverter
the output voltage is 3 ph 240 v

can i use it to run a 380 volt motor ???? , if yes the how do i wire it ?

thanks

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
BP Clone Conversion	Cartierusm	Bridgeport and Hardinge Mills	13	03-07-2009 08:09 AM
Best ICD2 clone?	ConKbot of Doom	PIC Programing / Design	4	08-06-2008 02:52 PM
BP clone CNC is Finally done!	triberman	Bridgeport and Hardinge Mills	21	03-25-2007 07:57 AM
X3 or RF45 clone?	logjammer	Benchtop Machines	13	12-14-2006 08:34 AM
Another Gecko clone??	TommyB	Gecko Drives	3	08-29-2005 12:35 PM

All times are GMT -5. The time now is 03:43 AM.