| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Phase Converters and VFD Running 3 phase machines on single phase power and variable frequency drive discussion |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-07-2007, 05:14 PM
| |||
| |||
I'm looking at a milling machine that has a 7.5/10 hp spindle - does this mean the spindle puts out 10 HP peak ? and 7.5 is max sustained HP ? Or what ? Anyways, I already have a new 10 HP RPC, would this run this machine ? Thanks for any replies.    |
|
#2
01-07-2007, 05:34 PM
| ||||
| ||||
| Usually that is 7.5hp continuos, 10hp for 30minutes. I have always understood that a RPC will run a motor equal to the RPC motor, this is due to the spindle motor now in parallel to the RPC motor, this does not apply to non-motor loads. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
