Results 1 to 2 of 2

Thread: VFD question

  1. #1
    Registered
    Join Date
    Aug 2005
    Location
    USA
    Posts
    248
    Downloads
    0
    Uploads
    0

    VFD question

    I recently purchased a Bridgeport EZTRAK SX. I have not powered it up. I am wavering between building a rotary phase converter or buying a VFD. I like the idea of a VFD but I have no idea about how to size one for this machine. Would anyone like to offer advice as to size and make of a VFD?

    Thanks,

    Ernie


  2. #2
    Registered krak's Avatar
    Join Date
    May 2010
    Location
    USA
    Posts
    105
    Downloads
    0
    Uploads
    0

    Call for Free advice

    I can tell you the easiest way to figure out what size VFD you would need, provided you will use the same motors, would to give automationdirect.com a call. They have some very good folks over there, and will really help you out, not just try to sell you something. GS2 vfds are simple to setup, but can handle a lot different apps. be sure to get the proper power protection. It will save you a headache or two, and maybe a few dollars.
    1.800.633.0405


Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.