Originally Posted by
MTMOOSE797
Need help. I have a Huanyang HY01D511B 110V 1.5 KW, 800W, 5A, 400 HZ, 24000 RPM water cooled spindle. This is not like those posted in other blogs/threads. I did not wire this. It came wired with 3 prong plug 110v/1.5kw from inverter to wall and then 4 prong screw fitting to spindle.
I enter the following and press run and error code E.O.C.A. comes up and spindle just clicks.
PD01 =0
PD02 =0
PD03 =400
PD04 =400
PD05 =400
PD07 =20
PD08 =220 (120 if you have 120v VFD on some threads I've tried both and 110)
PD09 =15
PD10 =8
PD11= 120
PD13= 8 (Only use if factory resetting)
PD14= 12
PD15= 12
PD141= 220 (120,... SAME AS PD08)
PD142= Motor max amps = 5Amps I'm guessing and have put that in each time
PD143= 2 (Its a single phase not triple, so guessing its 2 poles- can't find anything stating different)
PD144= 3000 (400HZ=24,000 so 50HZ=3000) Saw that on another thread.
PD70= 0
PD72=400
PD73= 120
That is all I have entered in the inverter. I have reset to factory settings twice and entered each one and double checked. Always the same answer--E.O.C.A and can't operate my new CNC. Help... please.