Results 1 to 1 of 1

Thread: sorry admin started new thread meant to post

  1. #1
    Registered dpot's Avatar
    Join Date
    May 2005
    Location
    FRANCE
    Posts
    68
    Downloads
    0
    Uploads
    0

    sorry admin started new thread meant to post

    I plan to keep the cost down as much as i can so plan to go for the Haoye 4.5" ducted fan unit it come in at $25 and the brushless inrunner KB45-17XL:5158 700Kv 36V is $53. I am go wing for 2 18.5v lipo packs that i use for my other models 2300mah 5s 20-30c $100 will need to go to 2 of the 5s 4500mah 30-50c $500 and play with the motor to give the best performance depending on the setup for power and finish of the model the wight should come in at 10 to 11 lbs

    go wing to cut and fit wing to day
    Attached Thumbnails Attached Thumbnails sorry admin started new thread meant to post-edf4withlipo.jpg   sorry admin started new thread meant to post-edf4withlipo4pack.jpg  


Similar Threads

  1. Cutting balsa and ply
    By markdib in forum Parts for Radio Control Models
    Replies: 27
    Last Post: 07-27-2010, 12:38 AM
  2. Spectra light and Light machine owners have ?
    By ZipSnipe in forum Benchtop Machines
    Replies: 11
    Last Post: 07-18-2008, 10:52 PM
  3. Replies: 2
    Last Post: 08-27-2007, 09:08 AM
  4. Bit for cutting balsa
    By dbtoutfit in forum WoodWorking
    Replies: 0
    Last Post: 06-18-2006, 12:52 PM
  5. cnc routers with balsa
    By zeslave in forum DIY CNC Router Table Machines
    Replies: 1
    Last Post: 02-04-2006, 12:57 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.