Need parameter for the spindle RPM. SOLVED. - CNCzone.com-The Largest Machinist Community on the net!

09-28-2008, 09:05 PM

g-codeguy

Join Date: May 2007

Location: USA

Posts: 896

Need parameter for the spindle RPM. SOLVED.

permalink

Is there one? I want to put the current spindle speed into a variable for use in a macro sub. This would be on OT, 18-T and 21i-T controls. I found where the orientation and maximum RPM parameters are, but didn't see anything in regards to reading the current spindle RPM. Google didn't turn up one either.

Thanks.

Last edited by g-codeguy; 09-29-2008 at 09:49 AM.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need parameter for the spindle RPM.	g-codeguy	Fanuc	2	09-29-2008 08:40 AM
ymc 60A parameter	saptyawan	CNCzone Club House	0	06-17-2008 12:45 AM
Need Hardinge spindle parameter.	g-codeguy	Fanuc	4	05-09-2008 06:12 PM
OT parameter, spindle stops when switching,	Ztiggi	Fanuc	4	11-07-2007 01:50 AM
How to setting fanuc serial spindle parameter?	ning	Fanuc	1	10-30-2005 03:38 PM

All times are GMT -5. The time now is 12:51 AM.