Read paremeter

[Bluesman]

Originally Posted by Osmanselim Sory Wrong writing I want to Machine paramater, For example Parameter number 6712 ; Total number of machined parts 6711 ; Number of machined parts 6751 ; Operation time (integrated value of time during automatic operation) These parameter write it the #500 = Parameter 6712 #501 = Paramater 6711 #502 = PArameter 6751 like this please help me

# of Machined parts #3901
# of requierd parts #3902
Current time in hours #3012 Read current time in Hours/Minutes/Seconds - ie: 3:56pm & 25sec = 155625

I attatched the entire Varible list for Fanuc

Bluesman

[Osmanselim]

thank you very much for your interesting

[chetan]

Can anyone tell me how to read system variables?

actual i want to display clock on crt monitor how can it be done. i read fanuc manual, i only came to know that #3011,#3012 are variables for clock information. Control is FAnuc O-Tc.

Do i have to set the bits of any parameter? If yes then which parameter No.? and how to change it?

How to enable this clock display on CRT? please give me the procedure. i m new to cnc

Thanks

[stevo1]

I have attached the procedure on how to look at the counters timers ect. Is this what you’re looking for or are you trying to set the control so you can view the time on the front of the control? I don’t know if there is a parameter to actually view the clock on the front screen. I don’t work much with the Oseries control so I am not very familiar with the fundamentals of it. You might also want to check 911.3 for clocks and counters.

Stevo

[Thu59]

Helo every one,Iam new. I have a problem with Amada,pega 344,CNC turet punch.That is alarm code :904 . If some one has idea,please help me.Thanks olot

[stevo1]

Welcome to the group.

You need to tell us what series control you are using.

Also just FYI in the future it is always best to start a new thread with the issue that you are having titled to match the problem. This thread is titled “read parameter” and is in the “parametric programming” category asking how to read machine variables. No one is going to think to look in this thread to help you out for an alarm on a punch press.

My guess is you probably have a Fanuc control on this machine. There is an area for Fanuc controls.
http://www.cnczone.com/forums/fanuc/
just click on the “New Thread” button.

Stevo

[chetan]

Originally Posted by stevo1 I have attached the procedure on how to look at the counters timers ect. Is this what you’re looking for or are you trying to set the control so you can view the time on the front of the control? I don’t know if there is a parameter to actually view the clock on the front screen. I don’t work much with the Oseries control so I am not very familiar with the fundamentals of it. You might also want to check 911.3 for clocks and counters. Stevo

Thanks stevo,

911.3 worked, it displayed the clock on parameter page. Do you have the list for paramaters for this fanuc OT? Can you send it to me? my email ID is primoris.eng@gmail.com