Looking for a GRBL forum. Where ?

[someguy123]

I'm looking for a place to discuss a bunch of GRBL things. Like a community forum.

Where would I find it ?

Are there any GRBL people here ?

[doorknob]

The GRBL discussions that I have seen here have been scattered in various places.

One place that might be good would be Open Source Controller Boards - CNCzone.com-The Largest Machinist Community on the net! (but there hasn't been much activity there).

(even though GRBL is software/firmware and not actually an open source controller board, when running on an arduino board it sort of is)

[someguy123]

Thanks.

[saimgee123]

Yes you can also discus about it in this forum and check this forum.
shapeoko.com/forum/viewforum.php?f=3
You can also discuss here about the all type of GRBL topics.