L267 plus IRLZ44N is the best option?

[lucasi]

Hi, I'm looking for a step driver Open Source to drive 3 motors Nema 23 , unipolar, 6 wires, 3A/phase, 1 Ohm/Phase, 2.0 mH/Phase.

I found some drivers here and I'm a bit confused, I have some parts to build a CNC3Ax (L267 plus IRLZ44N) but Im not sure if this is the best option to drive my motors.

I apreciate any sugestion...

Regards

Lucasi

[H500]

Take a look at the "CPLD Tutorial" thread. It has the best drive design I've seen so far.

[AndersG]

Agreed. Even if I am partial to my own design, there is no such thing as a "best" design. It largely depends on what you need.