| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Open Source Controller Boards Discussion for Open Source CNC type Controller Boards and other related items. (for personal use only) |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
03-01-2005, 10:40 PM
| |||
| |||
Any ideas on what is the easiest way for a diyer to control a pick and place arm custom built for one job only? 2 axis of motion, y travel 45 inches, z travel 3 inches. Any ideas for a standalone system/controller solution?? Could one of the pic boards be adapted to hold a simple motion program on board??    |
|
#2
03-01-2005, 11:19 PM
| ||||
| ||||
| If this is just a simple dedicated system, You pick up one of the stand-alone motion controllers like this one, http://cgi.ebay.com/ws/eBayISAPI.dll...sPageName=WDVW programmable in simple two letter commands. program with any PC through the serial port, PC not required to run it. Al
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SMD pick and place | ciccio | Printing, Scanners, Vinyl cutting and Plotters | 194 | 01-19-2010 01:34 AM |
| | |
Linear Mode
