Linistepper 32nd or 64th micro steps? - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > OpenSource CNC Design Center > Open Source Controller Boards
Linistepper 32nd or 64th micro steps?

Open Source Controller Boards Discussion for Open Source CNC type Controller Boards and other related items. (for personal use only)

This forum is sponsored by:

03-19-2008, 12:35 AM

Join Date: Feb 2006

Location: USA

Posts: 143

Linistepper 32nd or 64th micro steps?

permalink

I am using the linistepper for a telescope CNC project. I need as many microsteps as the PIC on the linistepper will allow. Any tips on how to reprogram the PIC for a higher microstep count than the 1/18th that comes stock?

-Jim

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
I think i am going the Linistepper route	phantomcow2	PIC Programing / Design	1	03-14-2009 12:19 PM
Linistepper update	posix	Open Source Controller Boards	56	10-14-2008 01:20 PM
Taig Micro Mill 2000 steps per unit	JV11	Linear and Rotary Motion	4	09-26-2006 07:13 AM
Full Steps -vs- Micro Steps	DJB282000	General Electronics Discussion	10	12-28-2005 11:25 PM
Linistepper	tante	Open Source Controller Boards	7	12-19-2005 09:24 AM

All times are GMT -5. The time now is 12:54 AM.