Results 1 to 2 of 2

Thread: 7 Amp X 5 Mosfet Array

  1. #1
    Registered
    Join Date
    Feb 2006
    Location
    USA
    Posts
    102
    Downloads
    0
    Uploads
    0

    7 Amp X 5 Mosfet Array

    SLA5046

    Just got a small handful of these ICs for FREE
    They appear to be an older IC but free parts is free parts.
    (I would have gotten more if I knew what they were
    at the time I just grabbed some because they looked
    interesting with that BIG heat sink die on the back)

    Mosfet Array, 5 Mosfets to each package
    3 ICs drive 4 five wire unipolar motors,
    and 3 Mosfets left over for other things

    Drain Current 7 Amps constant with
    about 5.5 Volts on the gate
    (if I’m reading the spec sheet right)
    possible 15 Amps pulsed

    Here is a link to the spec sheet I found
    http://www.allegromicro.com/skncatlg/array/sla5046.pdf


    EDIT:
    Looks Like SLA5024 might be a decent complement
    if you're running bi-polars, 4 Fets per package
    4 Amps constant, 8 Amps pulsed.
    http://www.allegromicro.com/skncatlg/array/sla5024.pdf

    Just thought I would point this one out to everyone.
    Last edited by scratch_6057; 01-27-2007 at 07:54 PM.
    Mike_L

    When I was younger I thought I knew EVERYTHING,
    NOW, the older I get the more I find out I don’t know!


  2. #2
    Registered
    Join Date
    Jul 2006
    Location
    USA
    Posts
    103
    Downloads
    0
    Uploads
    0
    okay.
    my head hurts now.


Similar Threads

  1. Mosfet Driver
    By tivoidethuong in forum General Electronics Discussion
    Replies: 57
    Last Post: 01-18-2009, 10:20 PM
  2. LED array sequencer
    By MrWild in forum General Electronics Discussion
    Replies: 11
    Last Post: 11-21-2006, 12:31 PM
  3. IR2184, HIP4080A, or other for mosfet driver?
    By originator in forum Stepper Motors and Drives
    Replies: 2
    Last Post: 11-02-2006, 10:31 PM
  4. MOSFET swaping
    By runnoahrun in forum General Electronics Discussion
    Replies: 4
    Last Post: 01-20-2005, 06:41 PM
  5. Linear Array
    By hay171717 in forum G-Code Programing
    Replies: 6
    Last Post: 05-28-2004, 02:18 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.