| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Open Source Controller Boards Discussion for Open Source CNC type Controller Boards and other related items. (for personal use only) |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-20-2005, 11:06 PM
| |||
| |||
Im new at cnc and I have three World Servo SSt- 1500 servo drives and three SSt-3437 servo motors. I would like to build a machine using these parts. What kind of controller board and software would work with this system. I think they take a 5 volt step and direction signal. Thanks greeny    |
|
#2
07-21-2005, 02:51 AM
| ||||
| ||||
| Greeny, You will need a controller that will handle the enable circuits properly so if one axis drops out it will take the others out as well. I will PM you with an e-mail address of a guy called Pete who can help. I myself can not post his info here so I will have to do it privately. Sorry everone.
__________________ "A Helicopter Hovers Above The Ground, Kind Of Like A Brick Doesn't" Greetings From Down Under Dave Drain Akela Australia Pty. Ltd. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
