Did anyone use this driver? - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > OpenSource CNC Design Center > Open Source Controller Boards
Did anyone use this driver?

Open Source Controller Boards Discussion for Open Source CNC type Controller Boards and other related items. (for personal use only)

This forum is sponsored by:

08-15-2010, 11:23 AM

Join Date: Apr 2008

Location: afyon

Posts: 1

Did anyone use this driver?

permalink

Did the driver's picture? I did not find parallel port. Mach3 settings can not be!

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Newbie- Best MOSFET Driver and MOSFET choice for an H-Bridge Stepper Driver?	joprinz	General Electronics Discussion	4	04-28-2011 03:57 AM
Newbie- driver	MR MOTION	Open Source Controller Boards	0	04-07-2009 05:52 AM
single axis driver and a b.o.b.,or multi-axis driver board	.xXACEXx.	Stepper Motors and Drives	3	07-02-2007 11:13 PM
STEPPER DRIVER FAQ {Stepper/driver amp per phase match.	huios	Stepper Motors and Drives	0	08-27-2006 08:43 AM
driver ?	morpheus	General Electronics Discussion	4	06-23-2004 08:12 AM

All times are GMT -5. The time now is 05:15 AM.