| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Open Source CNC Machine Designs Discuss Open Source CNC Machine Designs here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-14-2007, 03:54 PM
| |||
| |||
Hi, I am building a small (12"X24") 3 axis CNC router to make small parts and nampelates in plastic and aluminum and would like some advice on a resource for an all in one kit for motors and controller. Can someone direct me to where I could find a matched set for a three axis machine? Ofcoarse, I want to save some money but would like something that is matched up to save me from getting incompatable parts. I'm hoping to spend less than $300 if possble (less would be better) I will be building somthing similar to a Rockcliff cnc. Thanks for any and all advise!! Aaron  |
|
#2
11-14-2007, 05:22 PM
| ||||
| ||||
|
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hot Steppers! | xitian | Gecko Drives | 9 | 08-22-2007 12:38 AM |
| DeskCNC 2nd. gen controller AND HobbyCNC Pro Controller | maycom | DeskCNC Controller Board | 1 | 06-02-2007 01:33 PM |
| connectors for controller to steppers | Mcgyver | General Electronics Discussion | 7 | 02-03-2006 05:28 PM |
| Why Not Use Steppers | Steve Etter | Machine Problems, Solutions , Wireless DNC, serial port | 6 | 12-20-2003 10:04 AM |
| | |
Linear Mode
