| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Open Source CNC Machine Designs Discuss Open Source CNC Machine Designs here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-25-2007, 04:15 PM
| |||
| |||
Hi, I need some guidelines to build a small vaccum table drived by vaccum cleaner for engraving purposes. I have seen some models on e-bay, but I have no idea about the holes, channels map, pipes' size, etc. If somebody already experimented or built, please, give few clues to avoid trials & errors just to reinvent the wheel. Thank you, Zoltan  |
|
#2
05-25-2007, 10:35 PM
| |||
| |||
| Have a look at this thread Zoltan http://www.cnczone.com/forums/showthread.php?t=34537 There are a couple of other threads about vacuum devices. Have a search.  Greg |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| small cnc plasma table | morpheus | CNC Plasma and Waterjet Machines | 3 | 02-18-2009 08:58 AM |
| Best inexpensive servo setup for small 2x3 table | Ed Williams | Servo Motors and Drives | 6 | 08-28-2006 07:03 AM |
| Vaccum clamp | osdhillon | DIY-CNC Router Table Machines | 45 | 07-19-2006 07:34 PM |
| Vaccum hold down | avengine | CNCzone Club House | 3 | 04-24-2006 11:03 AM |
| Small Vacuum Table | CLaNZeR | Work Fixtures and Hold-Down Solutions | 7 | 04-16-2006 04:23 AM |
| | |
Linear Mode
