Hi...
I seem to be having trouble programming the EEPROM...
The HEX is OK, no problems there... I can compile and build using WinAVR...
I also tried a small program to blink the Error LED and that worked ok...
But... when I try to write the EEPROM, I get this message from WinAVR...
I'm using an ATMega8-16AU chip with the code from "Servo_AtMega_CompInt " ...Entering programming mode.. OK!
Programming EEPROM .. OK!
Reading EEPROM .. OK!
WARNING: EEPROM address 0x0010 is 0xFF (should be 0x2C).. FAILED!
Leaving programming mode.. OK!
I connected with the UART and got nothing so it confirms the EEP isn't programming correctly...
Any suggestions??
Thanks,
Michael