FYI

[BurrMan]

There is a typo on the OneCNC web page at:

http://www.onecnc.net/news/news_mult...evelopment.htm

and displays it in the planes dialog fro reference and automatic location for machining

Maybe someone should post this in the forum where they have access so they can have it changed.

FYI

[BurrMan]

Now that's Action.

[HelicopterJohn]

If you think that was fast action. Just have a little problem trying to figure out how something works and post it on their private forum and you get the same type of result.

Nice piece of software and great product support.

John

[BurrMan]

Hey that's great John.

[BurrMan]

Helicopter John,
BTW: I used to fly a JR Ergo 60. I'm sure it's advanced quite a bit since then!

[HelicopterJohn]

Hope you had a chance to check out the gallery on my website. If you scroll all the way down you can see a slide show or photos of some of the ole helicopters we used to fly.

My first one was a Dubro Shark with and O & R Engine on it. Fixed pitch and a real hand full to fly. Started flying them in the early 70's and all my machining adventures are directly related to that sport. Still fly a Raptor 50 today and have a lot of fun with it.

John

[BurrMan]

I checked out your gallery. Thats what promted me to post back regarding that. A friend of mine from High School used to fly F3C competition. He was pretty good. I was intrigued by that more than the hotrod 3d stuff. I was never that good though... Just a hack.