OneCNC and Logo art

[l u k e]

From what I've seen they claim you can reproduce logos in their program. I need to turn this logo into "line art" for some company tee shirts. I was thinking one could convert the art as if it were going to be machined into a part, but then save it as a picture in a jpeg file (or other) Would it be possible to do this with OneCNC? I have an artist that can reproduce the art but we are looking at a lot of time, which I want to avoid. The letter font is unknown, so it makes the project bigger than I want to pursue.

Here's the logo>
http://www.automags.org/pic/ttl/hdr_logo.gif

By the way I will have permission of the owner before I use the logo. His has allowed projects like this in the past..

Thanks

[HuFlungDung]

OneCNC has an image trace. Here is the geometry drawing it generates directly from your image. Then, you carry on and engrave it, or pocket it, or whatever. Sometimes the poorer traces require some fixup to make work, but that one seems quite clean because the edges are distinct.

[l u k e]

Very cool, thanks!