Hu,
There is one do out any day now. I'll let ya know if I get e-mailed before you do. You do the same.
Just wondering if I've missed anything in the last two weeks. I was right up to date before then.
Similar Threads:
- Need Help!- Waterline not working right on 3D curves and patches
- Need Help!- V20.7 Patches
- BobCad v20 Patches?
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Hu,
There is one do out any day now. I'll let ya know if I get e-mailed before you do. You do the same.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)