| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| OneCNC Discuss OneCNC software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-13-2007, 09:00 AM
| ||||
| ||||
I have XR2 Advantage, and am looking to do some raised letters, mirrored and on a curve to make a small stamp. What would be an efficient approach to this? So far my method has been to Chain Text, and then profile machine each letter. This seems very tedious. Wish I had a solid model of the design and could just z-level the things. But there will be many different designs of these stamps, with 40-50+ letters (font height about 1/4", and ~0.090 z height) on each design. Scott
__________________ http://www.scpconcepts.com  |
|
#2
01-13-2007, 11:53 AM
| ||||
| ||||
| Scott, You can just create a "boundary" around the letters and use the "pocket" function..
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
