| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| OneCNC Discuss OneCNC software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-04-2006, 01:28 AM
| |||
| |||
How would you gentlemen go about cutting an open pocket in OneCNC? I know how I'd do it in Gibbs. But how do you handle this in OneCNC? 
__________________ "It's only funny until some one get's hurt, and then it's just hilarious!!" Mike Patton - Faith No More Ricochet  |
|
#2
08-04-2006, 11:45 AM
| ||||
| ||||
| Mak, Personally I usually close the chain..only takes a second..But if you can't or don't want to do that... You can use the profile function with a "stepover" operation and it will stepover until it has cleaned the "pocket" out.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
