Reply with QuoteOK, tried sitting down with this... and maybe I cant figure it out after all. Started new thread with more details. This is getting very frustrating.
Haas ST-10Y post, anyone have one?
We have OneCNC lathe expert with all the appropriate modules and a Haas ST-10Y with live tooling. The posts that came with OneCNC are not giving the right code for the live tooling. Also, there are no canned cycles for axial or radial tapping with the live tooling. Does anyone have a working one?
I can edit it, but have limited time to sit down and get it all dialed in.
Thanks,
CG
Similar Threads:
OK, tried sitting down with this... and maybe I cant figure it out after all. Started new thread with more details. This is getting very frustrating.
CG,
Which post are you using??
Have you registered over at the OneCNC users forum??
Might do that and post over there. As there are more OneCNC specific resources over there.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
we were using the posts that came with the software, tried them all. Have since found out from OneCNC tech support that they are not complete. They are correcting that now and we will have a working post shortly.
Fair enough. Glad you are getting it worked out.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Re: Haas ST-10Y post, anyone have one?
ever find a post? we have a st20y that we need one for. any help would be greatly appreciated.
