2D Toolpath Start Point?

[mlinder]

WMS,

Yeah, that's how I used to do it.

Mike is supposed to call me this week. I'll talk to him about some of these things.

Thanks!

Mark

[peter]

mark
you can start anyplace you like on your profile in any of onecnc
products its quite easy, say you want to start mid point of a line
create a point mid point of the line break line at that point, then
when you pick your profile past that point it will then start your nc
code from that point including approach and depart
best regards
peter

[peter]

mark
it quite easy to create a start point (in any of onecnc products)where you want your profile to cut from.
say you wanted to start mid point of a line,create a point mid point of line break line at point then when you select profile
select line after break point and your profile will be cut starting at that point will also create lead in lead out at that point
regards
peter